I'm gonna try it regardless, and I listen to pt because he doesn't seem like a douche.
I came to this forum because it seemed like it was full of people with answers... So far, he's been about the only one who has repeatedly responded and has a decent idea of what's going on. Half of my posts...
Already lookin pt. good call though
There's always the chance the board failed... But you would sure want to make sure before you plug another in eh...
The other disco stays connected, and reads fine during startup, but starts too fast to get cranking rpm from starter. I'm gonna try pulling the ignition relay and see if it will read rpm not starting
So, It drops the obd scanner when I turn the key to turn over the motor... Then reconnects after the key is back in position 2. I e done it on every other vehicle I have, and it doesn't disconnect. It doesn't give me rpm on anything while running on the starter, but I think it's because they all...
Some of us just know what a fuel pump sounds like. It's not hard to tell if you'd like me to teach you. Maybe then you can also teach your monkey.
It's 100 degrees out when I get off work, I have 4 other cars... I'm not on this thing every second I'm home. If this isn't going fast enough...
Funny because that's what I'm trying to do. Can't get my hands on a scope until Monday,
Another funny thing, my 2000 disco runs the fuel pump for about a second when I turn the key to position 2.
There must be something wrong with it, since me, 3 other guys on here, the rover manual are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.