Search results

I've running the RTE Watts arms for about 8 months now. They came with the outer bushings, but now the bushings in the center link need replacing after my trip to Death Valley. AB lists $80 each for the upper and lower, and $90 for the center bushing. I know the upper is toast, bottom is...

The only thing I need to complete my next lift are the rear springs. As stated, I'm looking for a set of linear 3" RTE springs for the rear of my D2.

I just got a set of front RTE 4-3 springs. They are old (probably when Steve was running the shop), but have never been installed. They are labeled RR 4-3, but there is no stamp on the coils that I can see, and I'm looking for a tape measure here at work to see if that might help. I'm not...

I'm doing a snow run next week, and will be using chains (front and rear) for the first time. They will only be used while on the trail (which has no rock obstacles, just deep snow) and I have a few questions. Is it advisable to air down the tires with chains? If so, how low psi and when...

Searched and found this thread: http://discoweb.org/forums/showthread.php?t=25547 Today I had to get all new pads and the rotors replaced on the D2. My mechanic had to use a little persuasion to get the rotors on. He said it's because the steelies I'm running aren't hub centric and tweaked the...

Starting a couple days ago my driver's seat belt doesn't want to unlock and free spool very easily. It releases an inch or so then locks again. I'll gently let it wind up and pull and after a few minutes it will let out about12" of belt. After another minute or so of messing with it, it will...

Selling this since I now have a Greg Davis rear bumper. The 2 bolts that go up into the rear cross member (M14 85mm, grade 10.9) are not included as they were re-used for the bumper install, but all other hardware is included. Sorry, I don't do PayPal, email me at bcorns at gmail.com for any...

I'm looking for a set of roof rack extension bars for an '01 D2. Cheapest I've seen is RoverConnection for $175. If you can beat that (say $150) + shipping I'll be more than happy to take them off your hands. Also, if you have a set of crossbars w/ the key I'd take those too for $200...