I'm going to try this again!
D2 Mantec Snorkel! I know It's the longest shot in the world.....but if anybody knows of one or one similar in design, let me know!
Thanks!
Billy
Hi everybody,
I have a 99 Disco II. Ive got all sorts of issues mainly with the Y pipe that seem to be a contributing factor to me not passing emissions. I keep getting a bank 2 sensor 2 low imput code that is triggering the CEL. I have a broken stud on the drivers side causing a very big...
Here's what I've got!
Door panels for all 5 doors.... Decent shape, just switching to black for my project.
Center console...Same deal, decent shape. This one's been painted black and still has the tan lid.
Transfer case shift assembly... Includes a good cable. The boot is a little crappy...
I'm looking for the ceiling styrofoams underneath the headliner....theres two up front, and one above each door. Shipped to 98374 please.
Thanks so much!
Billy
Looking for a set of Black front seats in very good condition. Hopefully located somewhere in the Seattle / Portland area. OR shipped to me at 98374!!!
Thanks!
Hi!
I'm looking for a complete Epsom Green Cargo door for a Discovery II. I need the actuator, glass and the exterior trim. Not too worried about the inside panel. Shipped to 98374, or if you're in the PNW....maybe pickup.
Thanks!
Billy
Looking for a black interior for my DII (Headliner, A & B Pillars, Rear side window trims with boxes below, entire carpet and dash) Shipped to 98374.
Thanks!
Billy
SO I added Seafoam yesterday to help clean up the carbon left over from a bad maf and running too rich. Yesterday, it seemed like the truck was doing fine w/ the Seafoam in the tank. Today I threw a Cylinder 6 misfire this morning and then after I got to work, the truck would not start. I...
I'm thinking fins and things? Saturday Night At 5:30pm. Meet at City Market opposite side of the lot as the gas station. I'm in a Green DII. :D
Everyone's invited!
Come on, Let's Wheel!
BILLY
Today my Check Engine Soon light started blinking after about a week of running rich and a very rough/ stumbling Idle. It has gotten progressively worse since then. Now it almost dies when I push the pedal down and has very little power. Heres what I know so far:
-New plugs yesterday (Cheap...
My ignition lock cylinder on my 99 D2 is been feeing crappy lately and today when I was trying to go home from work the key would not turn the cylinder. How is the wiring setup to the ignition setup to bypass this with a push button start? I've heard of it being done, Just need to know what to...
Bought a starter and tire carrier from Marty (Drillbit). Made the payment on Tuesday, shipped Fedex ground Wednesday. Got it today (Friday) by noon! SO FAST!
Anything you guys need. Marty is the way to go for sure:D
Anyways....Great job Marty and thanks a ton!
BILLY:victory:
Ok, so my 99 DII takes forever to start (sometimes up to about 30 tries). When the key is turned, the starter runs, but does not seem like it is getting enough juice to power up fully to the engagement point. I just hear it whine. I took it out, cleaned the connections and bench tested the...
Looking for DS and PS turn signals and bottom finishers for my 99 d2. Cheap is always good. Broke as hell and have to pass inspection to register my truck in UT.
My front driveshaft grenaded itself a couple weeks ago and put a big dent in the side of my transmission oil pan. Now the lip of the pan and the gasket don't line up quite right and it leaks:ack: Looks like I need a new one. anyone have a super cheap non leaking one:bigok:
Thanks everybody...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.