Search results

I'm buying a D1 for my boys and found a used 98. In the description of the ad it says "The MAF is on the way out so it stalls once when first started". Any validity to this diagnosis or other ideas? Motor has about 130K miles. Thanks for the input. Patrick

I'll be at URE7. You coming?

@lunchbox...thx but I don't want to trim the arches. Want to keep the arches stock but still have some meaty tires that will still tuck up within the fender wells when fully articulated.

Sorry for the duplicate requests...my initial one timed-out when I submitted it and didn't see it post.

What the biggest tire I can put on a D1 with a 3" RTE lift with minimal rubbing? Please send pics with the setup if you got 'em. Thanks, Patrick

I'm helping a buddy build out his D1. What's the largest tire you can run with a 3" RTE lift without trimming and minimal rubbing? Thanks, Patrick

The differential needs a new pinion bearing but works fine. This unit will fit Series II, IIA, and III diffs, not Salisbury though. This is 4.71 gearing. Great if you want to rebuild it yourself or get it rebuilt while you keep your Seies on the road. $150 firm. Thx, Patrick

Marco, Thanks for the inquiry however these have sold. Thx, Patrick

They weight about 40-50lbs each. No packaging is required and I actually received these via UPS with a label attached directly to the springs. You could ship them UPS Ground. Thx, Patrick

They are not sold yet.

Mike26, Yes these will fit an SIII 88. I've got some new spring bushes I will throw in too Thx, Patrick

These are for the rear only. Sorry for the lack of clarity. Patrick

Northern Tool 1500lb. engine stand and 2-ton engine hoist. Both fold up for easy storage so they don't take up so much space. The engine hoist can be broken down without tools and easily fits in the back of a disco with the back seat down. Hoist includes engine leveler. Always garage kept and...

These are 3 leaf parabolics and ride very well. I have a 109 SW and the 3 springs were a little too soft for off-roading while loaded down. Located in Charlotte, NC. Pics http://s913.photobucket.com/albums/ac338/rovermud/Parabolics/?action=view&current=IMG00020-20100125-1352.jpg...

The guys on The Series 2 Club Forum are scary smart when it comes to Series. There is nothing these Brits don't know http://www.series2club.co.uk/forum/index.php

I'm am astonished you got that block out by yourself. Good luck. If you want to buy an engine stand, I will give you a deal on the one I have. See you in Dec at Uwharrie. Patrick

LR Flip, Sold! Come and get it. Patrick

Joel...I do have an intake. It's your for $25.

2.25 engine - bottom end and head. intake and accesories not included. It ran when removed it from truck 2 months ago. Kept in a garage. 4-speed Series 2 tranny with transfer case - Works but is noisy. 4-speed Series 2 tranny w/o transfer - works Pick-up only just outside Charlotte, NC...

Bill, Nice stock of 109's you got there. You got any straight left rear quarters panels for a Series 2 109 SW you would care to sell? I have been searching high and low. Thx, Patrick 1961 Series 2 109 SW