Search results

Thanks Paul.

Yes, it’s beyond repair. I have leads on several now, but I’ll let you know if I need to resort to the $300 option :D

Looking for a left front (US Driver) aluminum door threshold. The piece that screws to the floor between the door seal and carpet.

Looking for the grey plastic dash bezel. The dash piece that holds the heater vents and clock.

I'll take em. :)

The leather from the UK is the other option I've been considering... or just refurbed seats.. or just paying my local auto upholstery shop.

Thanks for the bump!

I'm looking for a set of 93/94 long wheelbase Range Rover Classic seats. Depending on the color I need either just the fronts or the fronts and rear seats. Looking for a set in very very good condition. I'm fine with replacing motors and fixing switches, but the seat frame, leather, etc needs...

Completely rebuilt 3.9l V8 short block + heads + extras $2700 Located in Mount Vernon, WA Never run. Stored in my workshop in plastic bags since the rebuild. The 3.9L block and heads came out of a 1995 discovery which was an interim year between the the v-belt 3.9l and 4.0l variants. It has...

Other than dislocating my knee and tearing a tendon Gord'n and I had a GREAT time! We unloaded the gear to make it lighter. It's tough competing against locked up rigs on a timed hill climb so we wanted every edge we could get. :) Craig

I think you and I are in the same spot. Hope we get them done by spring.

Nice PT! I was told differently, but if you've done it then you've done it. Sorry for mucking your thread up Will.

Yep, it's a fantastic addition! Just make sure you get a Defender linkage or an early RRC linkage (not a disco linkage) or you'll have to butcher the center console.

It doesn't. The DII doesn't use a speedo cable. You should be able to swap the rear output shaft to one that has the speedo cable though.

Kinda confused. Are they tubed or tubeless rims?

PM Sent

We'll see. There's one guy in front of me. Craig

PM Sent

Thanks Neil. I'll go dig around and see if I can figure out where that connector is.

I just finished replacing the main wiring harness in my truck and I'm down to just 2 wires that I can't find a home for. The first is near the e-brake and the second is near the shifter. I can't for the life of me remember what I pulled them off of, and can't see a matching connector for...