Search results

I got the "new" used hub from Will this afternoon. (Thanks Will!) Once it's installed with the new ABS Sensor, with the ABS computer reset itself? And will the three amigos go away? Or will I need to reset the codes?

I've ordered one from Will Tillary. I hope to get it on this weekend.

I was just looking at my truck and turned the wheels hard right and left. I noticed on the right front hub what appears to be the remains of a circular seal or something gone bad.

Guys, I recently did a brake job and replaced all four rotors and pads. Everything seemed fine. Used appropropiate amounts of grease on the caliper/pad touch points and behind the pad shims. I drove it for a few days and properly broke in the pads/rotors. Yesterday, I was pullng a trailer...

Will do.

No, I've never replaced the filter. Nothing seems to be leaking, no evidence of fluid around anything, plus the fluid in the resoviour seems consistant. I have read that the system is sensitive to the ingress of dirt.

I just read elsewhere that to delete the system, it just requires removing the pump, changing the belt and re-programing. Is that it? If so, how would it drive, as if no sway bar system?

I have a 99D2 with a 2" OME lift, steel wheels, 265/75R16 TAKO's. The truck has 110K Miles. I've never had an issue with the ACE system, and every other year would replace the fluid as routine maint. Recently, I've had the yellow ACE light come on. But no issues with performance. I had...

Just to follow up... turned out the stater was dead. I disconnected it from the battery and used a battery charger to try and turn over the stater before I took it out. no go! Got a new starter from NAPA for $179 and we're good to go. Thanks everyone!

Paul, I did mine a few years ago, As I recall I just moved the ACE pump and AC to the side. I didn't have to take them out. And as someone mentioned, there is a plastic inner fender you can remove to give you more access. Good luck! -John Shouldn't you be wrenching on an MG instead? lol

When car batteries charge they produce hydrogen. Though it is a small amount and tends to dissapate quickly, it's very explosive. I would keep it outside the cab and in a place where it can vent. http://wiki.answers.com/Q/Is_the_gas_given_off_a_car_battery_harmful

Somehow doesn't that engine look more powerful in an MGB?! lol

You could put it in my MGB! woo hoo!

Thanks guys, I'll check the relay in the morning. I'll also look at all the connections and make sure they are clean.

Just more out loud thoughts. I can hear the click when the shifter is P or N. But if I try to turn the key in any other gear there is no click at all. Weird.

I found a thread on the XYZ Switch. Seems it tells the ECU the location of the shift lever and won't let it start if not in Park. Mine won't start either in Neutral. Could that still be the XYZ switch?

Yes... Last summer.

No... Where is it? What does it do? I'll do a search.

I have a starting issue I can't figure out. When I turn the key, I hear a click and that is it. I've checked the battery. 2 Year old Otima Red Top, seems fine, sat it for a day or two on the charger and it's fully charged. Also lights and aux power seem to be OK too. I thought it might be...

I saw this Disco the other day on the Northway (I-87) between NYC and Albany. I really liked the white roof and wheels. My '992 is also oxford blue (like this one) but I have a SD Rack. Looks like he also had AB steel wheels like mine. I'm considering doing this to my D2. The roof is...