Search results

Hello My secondary air pump went out, looking for a used one for a 04 D2 Thanks, Derek

Hey all. I was working on one of the rovers over the weekend, and went to push my jack back down, but I turned the valve a little to much, and it and the fluid came out. So, what is the best way to get it to work again. Thanks

Hey all. I was working on one of the rovers over the weekend, and went to push my jack back down, but I turned the valve a little to much, and it and the fluid came out. So, what the best way to get it to work again. Thanks

I got my glove box back on, but it could use a adjustment. It closes but not all the way. I know there are some adjustment screw in the middle of the hinge. Any advice?

Hello, All. I was replacing my RH blower motor and putting my glove box back on. I heard it lock, but now I can't get it open. Help please. Thanks

Hello all. I pulled and clean my RH blower motor and did get it working, but the carbon brushes are low. I would like to replace them. Anyone know what the part number is, or where to get replacements? Thanks

Hey, all. noticed that my RH blower might be going out. I pulled and cleaned it, but sometimes it works and sometimes not. I going to pulled it one more time, but thought I would start looking for a blower now. Thanks. Dieter 1998 P38

Hello all. My 2004 D2 has a nice little cargo net in back, and I was thinking about putting one in the back of my 98 RR. Anyone have the net and Clips? Thanks

Hello all. I did a coil conversion on my P38 this weekend, and used a set of D2 coils. All went well, but the front of the car is about 3" lower than the back. I was told that the Defender coils would give me the extra I need. Any ideas what I can do to remedy this issue?

Hello all. I did a coil conversion on my P38 this weekend, and used a set of stock D2 springs. All went well, but the front of the car is about 3" lower than the back. I was told that the Defender springs would give me the extra I need. So, I looking for a set of stock Defender springs from...

looking for two frames that say Range Rover

My service engine soon light came on after a long drive over the weekend. I noticed my that some of the tubes to my Charcoal canister were loose so I pushed them back in. Now all is good. But what's a good way to keep them from coming loose again. Can I tie them or just re-tape? Tape looks like...

Mine is a bit worn. Anyone have one that looks clean still.

Mine is a bit worn. Anyone have one that looks clean still. and maybe a leather hand brake? Thanks, it's for my 98 P38A.

looking for that plastic cover that the screw goes into. my works, but is cracked.

Hello all. I'm still trying to get my shifter to work in low forward. It shifts fine in high, so does that mean the cable is OK? The transfer box ECU seems to work, when I put it in neutral it makes the switch to low. I can put it in P and R. My dash lights show low and P and R. As I try to...

Anyway to drain the liquid out of the mirror. Or maybe take apart a clean it out.

Hi, all looking for some opinions. I can shift to low from N and go into P and R, but if I try to take it down to 4, it stops. Other wise shifter seems fine. Thanks

Hello all. My passenger headrest won't go up. I feel the motor running if I put my hand there, but nothing moves. Any ideas? Thanks, 1998 P38A

at some point I'm going to replace the passenger side rear view mirror. It works, but does have a horz, crack in it. Easy to replace? Just the mirror itself.