Search results

Update: Fuel inertia switch - replaced Relay module - replaced Provided power independently to the fuel pump (double checked with volt meter) Still not starting. The fuel pump did not run with independent power. Am I to assume the fuel pump is the issue?

Update; I have power at the fuel pump. All wires look good. Replaced the fuel inertia switch. No luck on the engine starting. I have ordered the relay module. If that doesn't work, I am planning on replacing the fuel pump.

Where is the inertia switch?

My next move was to check the wires and the relay.

Wires are good and I removed the kill switch as the truck has been running with the kill switch installed.

Brand new battery.

Hey, My D1 has been running fine, but I recently installed a kill switch on the battery as I have had issues with the battery draining over time. I went to start it the other day and it cranks but will not turnover. I have checked the fuse for the fuel pump and it was good. I checked the...

Update: I went to move the D1 into the garage. I started it, put in in gear, and no movement. I checked under the D1. The rear drive shaft, no movement, but the front drive shaft is spinning and making a lot of noise. I cut off the engine and proceeded to push the D1 into the garage. Now the...

Ray, Yes, the drive shafts are connected. The transmission is an automatic. The CDL was in HI and had not popped out and the gear selector is moving smoothly. Thanks...I should have been clearer in my description. Todd

Are the transmissions rebuilt or straight out of a used D1?

I need some technical advice. My transmission went out on my 98 D1. I was driving heard a clunk and lost power to the wheels. I checked to make sure the gear had not popped into neutral. Once home, I checked the trans fluid. A little low so I added a quart and moved the gear from drive to...

I am looking for the hand brake assembly for my D1. The cable is good, but the release button is shot.

My brake lights do not come up when the vehicle is not running. Turn the key in the ignition and they work perfect. Is this normal for the D1?

This is an AWESOME outline (thanks to d1driver) and Roverguy.com delivers a great product!

Has anyone used Dexron-VI by Valvolin for power steering fluid?

Worked like a charm! Thanks for the help!

These rivets are for the rear bumper sill. I think they are similar. So you pull them out and then reinsert once in the hole?

Do the stock plastic rivets, RNF755, used to hold on various parts require a special tool to install? I have tried pushing the rivet into place, but it does seem to be expanding the backside of the rivet. I didn't know if it needed heat or a special tool.

Do the running lights located on the corners of the front and rear bumpers have their own fuse? None of these lights are working, but all other lights are operational. I've checked all fuses and they are good. I was warned about the electrical on these vehicles and it is a learning experience.

Great outline! I will let you know if I get stuck.