Search results

I am batling a loose steering situation with My disco. Almost everything has been repalced.... Hubs, tie rods, pan hard rod, drag link, steering box, lower steering shaft, power steering pump, watts linkage. I have adjusted the tension on the box (maybe too much) but still have a loose...

4.6 L Bosch out of a 2004 discovery II 140K miles. Engine ran great, but coolant would pool in #4 cylinder after running. Pulled it and replaced with a top hatted long block.

Time sert kit - used once. Part number 12188. 7/16 -14 thread repair kit with 9 inserts. Kit includes drill bit, guide plate, bushing, bottom tap, and insert tool. Used once (successfully) on 4.6L Bosch. PM me if interested....

Just completed the following: new Head gaskets, coils, wires, plugs, injectors, engine mounts and radiator. Rig ran great for a couple of days, then P0304 popped it's ugly head. I had P0306 prior to the head rebuild, then the gasket blew into the valley. The gasket was blown @ #6 at about...

I had a code telling me I had a bad upstream bank 1 o2 sensor, and running lean. Drove it a little until I was able to change the o2 and the P 0306 code showed up. The misfire is noticeable for sure. Pulled the plug, looked a little oily, not terribly, replaced it. No change, got an inline...

my 2004 disco II has recently developed a hot start shyness. At cold she fires right up, but after getting to temperature she takes considerable time to fire. I have cleaned the MAF, thinking that might be the culprit, but no real change. I have a fuel relay switch and crankcase sensor on the...

When I bought my 2004 Disco, the prior owner said he put a new water pump in. It runs fine until it gets cold (less than 45 degrees... I know it's So Cal cold). Then on start up, and for 20 -30 seconds it whines like it's running dry... then slowly fades. I am wondering if the prior owner...

I am about to embark on replacing the rear hub assemblies on my 2004 Disco II. Had a bear with one of the front Axle nuts.... could not get it off at all. Snapped 1 1/2 inch ratchet and 2 3/4 to 1/2 inch reducers (couldn't find a 3/4 drive 32mm or 1 1/4 6 pt). Have a new half shaft oil seal...

I have a 2004 Disco II with a Terra Firma lift, custom front shaft, rebuilt rear shaft and flex joint, but I have vibration at 45+ Mph under load as well as no load. If I maintain speed, with no large load I have no vibration. Took it to my driveline guy and seems to think the lift is causing...