Search results

I'm having a traction control issue that I hope someone might be able to point me in the best direction. Vehicle is a 2004 Discovery with 149,000 miles. No codes in vehicle and drives normal until you go over a railroad crossing or similar type bump then the traction control light will come on...

This is a new in box WABCO ABS Modulator Repair Kt $45.00 shipped

New in package genuine factory lower radiator hose for a 97 Land Rover Discovery 1 with AEL. $47 shipped Jon

I have 2 CD changer magazines left over from my old truck. Shipped from Tampa FL $30 for both Jon

I have spoke to Mark @ D&D and this kit will fit all D2s 4.0-4.6 Complete D&D cam kit with 5,000 miles. Kit includes: Camshaft Lifters ( Removed in order and marked to go back to lobe it was removed from ) Camshaft Gear Crankshaft Gear Timing Chain Camshaft Position Sensor Spacer ( Spacer...

Land Rover Discovery II Tires SUMITOMO HTR SPORT H/P 255/55/R18 This is a complete set of matching SUMITOMO HTR SPORT H/P 255/55/R18 removed from a 04 Land Rover Discover SE. The tires are in nice condition and have 9/32 tread depth. No patches and only removed for a wheel upgrade. Asking $175...

I have a 2004 Discovery that has a vibration from 55 - 70 MPH. The vibration is in the vehicle and is some what a hermonic drone. If I remove the REAR drive shaft vibration is gone. This is the list of things that have been done over the last week or so. New Roto Cupler Moved rear shaft 180*...

I have a oil leak on my 97 DI that I have been chasing for a while and I’m starting to run out of ideas. The leak is in the passenger side of the engine and so far I have replaced Oil cooler hoses Oil Pressure Switch Valve Cover Gaskets After replacing parts I cleaned engine and after a...

I'm looking for a good head light/turn signal switch for a 97 DI.

I need a good used starter for a project 97 Discovery. My zip is 33510. Thanks Jon

I'm looking for a starter for a 97 Discovery. My zip is 33510. Please give me a quote shipped. Thanks Jon.

I have not found a picture of correct orientation of front hub seals. One of my hubs had seal body flush and lip sticking out and the other had seal deep enough so the lip was flush. After a search I am not sure and looking for confirmation on what is correct.

Item#: BSH13969 Price: $68.99 tax and shipping not included Disclaimer: The stated price may vary from the in store price and may change at anytime. Attributes: # of Connectors:1 # of Wires:4 Heated or Unheated:Heated Wire Length:21.654" Additional Contents:Unit only

I have seen this on ebay and wanted to see if anyone has had good luck using on a 97 D1. I was under the impression that the sensor was different from 96-99 D1 and D2 but auction lists the same sensor for both. Is it just the plug that is different...

I have a very minor coolant leak. The expansion tank after months is down 3/4". I noticed the thermostat had a slight Drip nothing major and I plan to replace the gasket no biggie. Well today I was under the truck and noticed a very small trace of coolant where the head meets the block on the...

After much searching I have found many different answers to when Carbon Cutter valves were introduced. The earliest I have seen is mid to late 97. I am very interested as I have a late 97 with 127K and have not had any valve issues to date. Knock on wood!!!

I am looking for stock replacement radio for my 97 Disco.

I have a problem with my 97 D1. It runs fine and gets 14-15 MPG. It is smooth and makes good power. Now for the problem if it rains or gets wet it will idle fine but it will not rev and does nothing but stumble and miss. Yesterday was the first time it has happened in a long time because we have...

For the last 5 months I have had an off and on problem with engine missing, kicking, and backfiring out intake on my 1997 D1. 98% of the time it runs perfect but once in a wile above happens. When the problem starts it is usually the first start of the day, and it feels like something is wet...

I have been searching for a wile and do not see a match for my problem. I ran my 97 D1 2wks ago and it was fine. I have never had any real problems till now. I started it tonight and it fired up like normal and then I noticed a slight miss. It was low on gas, light was on so I thought it was out...