Search results

  1. R

    Will not run...weird...it hates me

    ...all it is getting on codes so far is random misfire? Anymore ideas?
  2. R

    Will not run...weird...it hates me

    nah...the fuel door was closed. I drove for 100 miles or so with it off. Like I said, fuel it back up, capped it and pressurized the system. Just wondering if I threw some thing off. The Disco is finicky at best, so I am digging. Can't get a scanner for a couple of days. --- anyone in...
  3. R

    Will not run...weird...it hates me

    ...anything to do with having left the fuel cap off?
  4. R

    Will not run...weird...it hates me

    beats me. I originally thought it was because it was low on fuel and the gas cap was left off. But I fueled it up, cycled the pump and few times and pressurized the tank. I can't find squat. out to get a scanner. I am sure it will show miss fire/etc and not the issue.
  5. R

    Will not run...weird...it hates me

    Yeah, I realize you can't adjust it. I just figured the two things that have a hand in injection and timing are the cam and crank sensors. I a green on these... the VSS will cause it not to run? Thanks all...I'll post back soon. Fortunately it is 40 degrees and pouring rain!! SWEEEET!
  6. R

    Will not run...weird...it hates me

    I'll get to it in the morning...thanks for any and all input.
  7. R

    Will not run...weird...it hates me

    Ran fine for quite some time afterwards. Later on, it began to idle rough...then badly...then, not run at all. When it does "run" it stumbles badly, misses all over, and coughs through the intake (bad timing?). What can I check? Cam position sensor, crank sensor? All the intake areas looks...
  8. R

    03 Disco Austin, TX $13,500

    Sold.
  9. R

    03 Disco Austin, TX $13,500

    Sale pending.
  10. R

    03 Disco Austin, TX $13,500

    2003 Land Rover Discovery 67,000 miles, power everything, quick and nimble on it?s feet, extremely well taken care of one owner vehicle, all services current, title in hand clear and ready for its new owner, never abused, never off roaded and exceptionally clean, please call 512-554-1544 (we're...
  11. R

    Rear hatch panel

    I need to replace the door handle on the rear hatch... what is the best way to pull off the inner trim panel with out snapping off all the clips? Thanks for the input and all help is appreciated.
  12. R

    Ignition Switch: New in box: $95 Shipped.

    For sale: New, never even been taken out of the shipping box: Ignition Switch for a 1997 Disco. Will fit rover classic and '95 up series I Disco. $95 Shipped.
  13. R

    column lock...classic issue?

    The whole truck dies when I unplug the switch. I have been chasing my tail here. I just tested the voltage to the small wire going to starter (solidoid switch wire) and it's cold when it needs to be and momentarily hot when the key is turned to start. If it were constant on the switch would...
  14. R

    column lock...classic issue?

    TOP... I need help with this pronto if anyone has the time to look this up or is knows enough to help. Could it be the starter?
  15. R

    column lock...classic issue?

    bill, thanks for the tip. I have the switch out. Now I just have to figure out if it is in fact the ignition (electric) switch leaving the starter hot. All wires are hot in the RUN position and the printed white wire (red stripe) momentarily goes hot when you bump it to START. It does not...
  16. R

    column lock...classic issue?

    By the way, I have been trying to knock out the "brake away" bolts that hold the ignition switch to the column, but they are'nt budging. Do I need to get that out before I can D/C the harness? The the ignition switch is on the fritz, I am going to make this thing push button start... I've...
  17. R

    column lock...classic issue?

    Ok, how do i get the harness out of the ingnition lock/cyliner? Its a round body and I don't see any tangs holding it in...possibly those two tiny silver screws that a miniature man could not get too?
  18. R

    column lock...classic issue?

    ok, i unplugged a two pin connector just below the lock cyliner and it gave me my key back while the batter was connected. Now, I just can't get the starter to quit spinning... I really would like to fix this without ordering a part out of houston.
  19. R

    column lock...classic issue?

    RichardS...which wires are to the transmission interlock? I had all this on the computer (shop manual) but the file is corrupt. I should probably try that first. My other concern is the starter still spinning once it's fired up and running. Could it be the whole think is taking a dump on me...