Finally got all the parts back from the engine shop yesterday where i had the crank, crankshaft pulley, flywheel, piston and rods balanced, along with new cam bearings installed for the crower cam. Also a much needed valve job.
So far today i got all the freeze plugs installed with a block heater, Cam installed and the crank / new timing chain in and torqued.
Next is the Pistons, front cover, new lifters/push-rods and heads w/ARP studs.
Any info (not in the manual) that others have found when doing a rebuild that will help?
This is a 2001 4.0 no with 4.6 crank and rods.
Thanks
So far today i got all the freeze plugs installed with a block heater, Cam installed and the crank / new timing chain in and torqued.
Next is the Pistons, front cover, new lifters/push-rods and heads w/ARP studs.
Any info (not in the manual) that others have found when doing a rebuild that will help?
This is a 2001 4.0 no with 4.6 crank and rods.
Thanks