That's it, just let the poison seep into your viens. I could have put a set of tits on my wifes back for what I spent on my last D2. And it would have been a more fun ride.
That's it, just let the poison seep into your viens. I could have put a set of tits on my wifes back for what I spent on my last D2. And it would have been a more fun ride.
They were taller, but I don't recall measuring to see by how much. I pretty much just tossed them in as marked (DS/PS). Let me know how yours ended up sitting, I had to add 2" spacers underneath those TF027s to get the truck sitting back right. I'm a little disappointed. This is the truck sitting (squatting) on the TF015s in front, TF027v in the rear, no spacers
After install, it was sitting about 1/4" higher on the driver's side, probably dead level when I sat in it.
Ok so there is no obvious difference in height between the left and right side?
The kit came with 1" spacers, and I have D1 spring seats for the rear.
What kit is this? Do you have a link? Dose anyone know if theses are the springs used in the Lucky8 3" kit?
Okay thanks. Anyone know if the D1 TF018 front spring will work for 3" on a d2?
The spec look like they are almost the same as the ome 751s
No, probably not.
They won't work at all or just less than 3"
D1 springs will lift the front of a d2 approx 1" less than on a d1.
Dont you mean D1 springs will lift a D2 1" MORE than a D1?
That's what I thought.Dont you mean D1 springs will lift a D2 1" MORE than a D1?
X2. But then again Kyle does have FJ80 axles on his truck so it could be the other way around.