Does anyone have a pic of these things installed? I'm having a lot of trouble getting them lined up. Some idiot (me) took them apart, and now that I'm having trouble getting them installed I am second guessing that I put them back together correctly.
Thanks
My 2000 D2 has recently started to just die. I drove it to the store and when I came out it wouldn't start. After cranking for about 10-15 mins it fired right up and I was able to drive it almost all the way home. Just as i entered my neighborhood it died with no warning. It didnt run rough, it...
I have the new seal in hand, but I'm not completely sure how to replace it. I checked rave and the instructions are less than helpful. How should I remove it and what is the best way to get the new one in without the special land rover tool?
Thanks
Doug
I purchased these and used them for about one week and one wheeling trip before I realized they were too short for me. I had some custom ones made and these have been sitting in my garage for about 3 months now...
I have 5 BFG mud terrains for sale. One is unused and the other four are about 70-80 tread left. I have used them offroad and there are a few small gashes in the sidewall, nothing structural and I have taken pictures of the cuts. They balance very well and show even wear.
Looking for $600 local...
I moved up to the 4.5 in lucky 8 springs and now need to get rid of my RTE 3 in springs. I bought them used and drove them for a few years, but they seem to be just fine. Located in northern va. I can get these to the conclave if someone wants them. Looking for $250
Thanks
Doug...
I have a front and a rear stock geared Arb locker for sale. They are the newer Arb rd128 locker. They both have the "new" bulkhead fittings. Located in northern va. I will not be at the conclave, but can get them a ride there if needed. Asking $1500 but open to offers.
Thanks
Doug...
I installed a set of Ashcroft axles and cv's on my D2 a few months ago. I'm currently trying to swap out my third members and it is a really big pain In the ass that I can't pull the cv through the knuckle with the boot and clamp still on. So is there an easier way than clipping the cv band and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.