Search results

WTB RRC/D1 full exhaust, preferably in the DFW area.

Does anyone have a 95 RRC swb and 94-95 D1? I need some help identifying if the hard/metal heater lines are the same. At some point po's of my 95 rrc swb changed the metal heater lines to earlier model lines. Just want to get it back stock because finding the right rubber soft heater coolant...

Title says it all. Is the cat y pipe from 94-95 D1 a direct swap/exact fit to a 95 RRC?

97 D1. Can't figure out how to remove the front carpet because of the strip over the tunnel without cutting it or removing the dash.

Need matte black vinyl 'Land Rover' hood lettering for D1. All I can find is silver or dark silver and or raised. Anyone have a source?

Looking for D1 front and rear extended ss brake lines with 2-3" extension,

What design, type and size of wood have yall used to make cribbing blocks that safely hold the weight of these rovers?

96 auto D1. When leaving from a stop auto trans feels like slipping the clutch to engage 1st in a manual. Almost like it winds up and the goes, rest of gear changes are fine. I will say my tcase leaks like a sieve that may have run a little low. For the last 20k miles upon accelerating from a...

Need to replace my D1 oem radio display bulbs. Does anyone have any idea on specs for these things or where to get them?

Stripped the coolant temp sensor and now can't get it out. Am I the only jackass that has done this?

96 D1 with 3" lift. Steering wheel typically sitting a little counter clock wise at about 11:55 I think due to having a stock pan hard rod, I could be very wrong about that, but that isn't the problem. Here is the problem, got in it last week and the steering wheel is at 10:00, when steering...

I have a couple part D1's sitting that I pilfer from for my DD, just wondering if there are any parts that you recommend pulling off a truck right away rather than let it sit on the truck?

Just like it says in the title, looking for a cat back Magnaflow or NRP exhaust for D1.

Anyone have a D1 mantec snorkel template? I know the the instructions suck balls, but I just need a starting point on where to cut.