Search results

  1. C

    Front Axle Adjustment Leaking Seal

    Seal is installed in correct direction, same as you indicate.
  2. C

    Front Axle Adjustment Leaking Seal

    I have replaced my front axle seal on my 2004 Discovery 2 two times and it still leaks. I tried OEM LR and NAK seals and both of them leak. I noticed when I put the second seal in that the axle alignment was not centred, the seal I took out was in good condition. I am wandering if it is...
  3. C

    Knock Sensor Code

    Thanks for the information, I will check to see if that is the case.
  4. C

    Front Axle Seal Installation Advice

    I have a 2004 Landrover Discovery that had a leaking front axle seal. I replaced it with an original Landrover seal and it still leaks. I was careful with seating of the seal and lubed it during installation. It is still leaking. Any advice or tricks on installing these seals so they do...
  5. C

    Normal Engine Operating Temperatures for 2004 Discovery 2

    Thank you for the information, appreciate it.
  6. C

    Normal Engine Operating Temperatures for 2004 Discovery 2

    Hi I am looking for some feedback here on typical operating temperatures. I have a 180 F thermostat and my temperatures normally run about 194F during City driving and drop to 188F on highway. In traffic at idle in stop and go traffic it has gotten as high as 202F. I am thinking of doing the...
  7. C

    Knock Sensor Code

    My vehicle is a 2004 SE with 4.6 L engine.
  8. C

    Knock Sensor Code

    I was getting a knock sensor code on bank 1. I replaced the knock sensor and it went away for a couple of weeks but is back now. The wiring from what I can see looks ok. Anyone have any thoughts on what it could be. The engine is running smooth so not sure what could be causing it. I am...
  9. C

    Valve Cover Gaskets

    Is it necessary to remove the intake to change the valve cover gaskets on a 2004 Landrover Discovery 2. The valve cover gaskets were changed about 20,000 miles ago and they are leaking again.
  10. C

    Traction Control Problems

    I ended up having to replace both rear hubs. Problem solved and all lights are gone. I used scanner live data function and noted that one wheel was reading 0 speed so traction control was kicking on. I found that both of the rear hubs had poor signals likely due to wheel bearing issues.
  11. C

    Traction Control Problems

    I did the B fix for the 3 Amigos and now I am having issues with traction control kicking in on dry pavement. Prior to fix ABS, TC and HD lights were on but no issues with traction control and driveability was good. I scanned ABS system and it indicated left rear sensor not indicating any...