Search results

  1. agbuckle98

    P38 transmission interchange

    Other than the pan, are there any differences in the transmission from a GEMS P38 to a Bosch P38? Would I be able to take a trans from a wrecked '01 and install in my '98?
  2. agbuckle98

    Intermittent power window failure

    This has been going on for a while, but getting much more frequent lately. 1997 D1, at times, EVERY window, including sunroofs will refuse to work. They may come back in a few minutes, or it may take an hour or so, but when they work, everything works perfectly. I've swapped window ECUs...
  3. agbuckle98

    LR4 Center console removal?

    Anybody know how to get the center console out on an LR4? My wife lost her wedding ring under it while fishing round for the phone that dropped between the seat and console.
  4. agbuckle98

    Transmission failure 1999 D1

    My D1 will no longer shift to 4th gear. No matter how fast I go, no 4th gear. All other gears work fine, no slipping. It also seems to like to stick in 2nd, both accelerating and on decel, it sometimes will refuse to get back into 1st. Fluid is nice and clean, very red, no burning. Now I...
  5. agbuckle98

    ipad OBD2 scanner?

    anybody here use an ipad as an OBD2 scanner? I would like to be able to use mine to show live data, pull codes, you know usual scan tool stuff, but the ipad has such a nice screen to view it all on. Google search doesn't seem to reveal much, I find it hard to believe that nothing good exists...
  6. agbuckle98

    D1 NON A/C serpentine belt

    anybody know off hand what belt would fit a D1 if the A/C compressor were no longer part of the equation?
  7. agbuckle98

    D2 ABS Tactic Error

    Had my '04 into the local shop a few times to get the ABS codes read, but the Testbook machine keeps bringing up a "Tactic Error" message and refuses to go any further. They say they have never run into this problem before, mine is the only car that does it. :banghead: Anybody heard of this before?
  8. agbuckle98

    RRC idle problem, stall on acceleration

    1990 RRC idles very low, eventually stalls. Also hesitates badly when starting from a stop, once above about 1200 RPM, it will pull like nothing was ever wrong. Idle problem started while wheeling today, temps were 85 - 90, engine very hot, aux fans and clutch fan engaged almost all day. 2...
  9. agbuckle98

    DII quarter glass removal

    Anybody know how this is done? I really hope it's not a glue in type deal. I see a rubber seal behind the edges of the glass, but it doesn't really make sense how the windows are held in place. RAVE says nothing about glass repair.
  10. agbuckle98

    Bear Camp Road

    There is a show on TV right now that makes me want to throw up. Anybody else watching "wrong Turn" on 20/20 ABC? This is just a show about unprepared idiots and the idiotic things they did to not get themselves out of trouble. Anybody know if Bear Camp Road is still open for travel to...
  11. agbuckle98

    Kalahari driving lamp wiring

    I'm trying to find a wiring diagram for the front driving lamps for a 2002 Kalahari DII. They work intermittently (maybe 5% of the time) and I have no idea what is going on. I have ruled out the switch, ground, power supply, and the signal from the brights. This looks just like the factory...
  12. agbuckle98

    Ignition coil puking

    1994 RRC, was driving trails today, and smelled something burning so I stopped, opened the hood, and there was a bunch of black tar type stuff all around the ignition coil. The coil itself was really hot, and it looked like it had been spewing this stuff for a little while. The truck actually...
  13. agbuckle98

    need help with brake part

    There is a "thing" on the passenger side firewall of my D90 that has 4 brake lines running in / out of it. mine is leaking, I can't find it on any parts diagram, the stupid dealer doesn't know what it is either. Anybody here know what that thing is? Sorry, don't have any pics right now.
  14. agbuckle98

    truck campers

    http://www.fourwheelcampers.com/ Anybody have one of these, or know anybody that does? I know this isn't exactly Land Rover compatible, but lately my energy for dealing with stupid Land Rover problems has been waning, and I want to get an '04 Tacoma, kit it out, and fit it with one of these...
  15. agbuckle98

    is this a dropped liner?

    1998 4.0 SE. I was hoping just head gaskets, but I noticed yesterday while cleaning up the block to bolt the heads back down with new gaskets that there seems to be just the slightest ridge on #5 cylinder as if the liner is just below the deck of the block. #7 seems to be this way as does #6...
  16. agbuckle98

    98 Disco won't start ...... AGAIN!!!!!!

    So I've been through this no start thing quite a few times with this truck, now I have yet another version of the no start. This all started after a car wash in my garage this morning, so I'm thinking it has something to do with getting wet, but who knows. First, there is no CEL at all...
  17. agbuckle98

    D2 O2 sensor diagnosis help

    2002 D2. O2 sensor bank 1 upstream causing check engine light. I replace sensor, it is unresponsive. I get new sensor thinking initial replacement was faulty, still no response from the sensor. I swap upstream sensors side to side, problem stays with bank 1. Now I'm into RAVE wiring...
  18. agbuckle98

    Heater core flush L322

    Just put a new radiator in my Mom's '04 Range Rover. I cannot get any heat at all from the heater. I was going to flush the heater core and it looks like 3 lines going to it. I looked in RAVE, sure enough, there are 3 lines off that heater core. Whats the deal? Anyone familiar with this system?
  19. agbuckle98

    Transmission swap question

    Anybody here know if a transmission taken from a 2000 4.6 Range Rover can be used in a 2000 DII? I'm sure bell housings may be different, mounts, ect, but the actual transmission itself, can it be swapped over?
  20. agbuckle98

    Cam stuck

    so I'm doing the cam replacement on my DII over the holiday weekend, everything is torn down, the cam is ready to come out, or at least I though so. It only moves back and forth about 3/8" and refuses to come out of the block. Yes, the thrust plate is off. If I try to twist it out of the...