Sold
Purchased Spring 2007 and I am the 2nd owner. Currently has 127,000 miles. 1st owner had all maintenance done at Bob Moore Land Rover in Edmond, OK. I had the 90,000 service completed there in June 2007 and have done all other maintenance myself since.
Truck has following options from...
Yes. Seat down and back stuck in down position. Guess I will try that. I have slammed the seat down to ensure it latches properly and that has worked in the past but not now.
Steve
I have a 2001 SE7 and cant get the back of the passenger side jump seat to open. Lever does move but not unlocking the mechanism that allows it to open. Any ideas?
Steve
Give me a shoot when you get here. Small place to wheel below Keystone damn. Disney is not that far away also. Never been there but would like to go.
Steve
I went to high school at Sand Springs (right outside of Tulsa) and my wife is from Jenks. Both our family is still there so we visit quite often. I currently live about 90 west in Shawnee.
What did you need?
PT you might want to go to www.therangerstation.com and contact Jim Oaks over there. Ford went after him a little over a year ago. After a month or so they were able to come to some type of agreement. Good luck and give them hell.
Steve
PT could you please expand your instructions on inserting an ampmeter in the ground circuit? I can't figure out how you would do this. I'm having similar problem with my Bronco II.
Steve
To to dealer and order one for a D1. Took a couple weeks to come in and was only 3-4 dollars. It will show the direction of the CDL along with the high/low as in link.
http://www.discoweb.org/forums/showthread.php?t=57668&highlight=CDL+Sticker
Steve
yeah I had thought about replacing also. Looks like it will be cheaper in the long run.
Also in the mean time I'm not going to do any damage to the truck by driving it with the CDL locked until I replace/fix the front D/S?
Steve
Good call Musky. I removed the front D/S and the noise went with it. Just checked my receipts and I had it rebuilt 7/10/07. 2 years was all it lasted.
Does anyone know if there are u-joints available that has the grease zerk? The ones I bought last time didn't. Also what about that big...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.