Search results

Picked up an 02 disco for my son yesterday and it has ace that I'm guessing has been disconnected for who knows how long. The guy I bought it from kept telling me it cost 4 grand to fix it. Been looking around a bit and it looks like it can be removed and just put sway bars on and a shorter...

Prior to replacing oil pan gasket very minimal leaking from that area. Replaced it started leaking at the back of the pan where the long bolts pass thru. Put it in with no rtv. Replaced the gasket used rtv still leaking at the same place. It seems to be a pretty decent little leak defiantly...

I replaced the track rod and drag link bar on my 03. Had it lined up and afterward the wheel had a lot of pay and wasn't centered and the print out had a lot of red on it. it was all over the road. Finally took it back after 1,000 miles told them the issues and the wheel was off center. They put...

95 D1 with no sunroofs. I’ve got a leak in the drivers footwell that I’m thinking is coming from the drain. No sign of a leak anywhere so I’m guessing it’s from behind the panel that has some electrical connections. What’s the best way to clean out the line or replace? I’ve followed it back to...

95 D1 5 speed wont start. New battery about a month ago. has power inside and on dash, radio and fuel pump. Tried jumping it off and just will not crank. Its been kinda slow turning over and just about didn't start this morning just like a dead battery. I'm going to pull the battery and have...

Replaced front cover, seal, timing chain etc. Put everything back together tired it up runs great….. except a leak at the seal. Pulled it thought it might not have been seated all the way. It leaked almost immediately and stopped as soon as the truck was cut off. Had a new seal put it in and ran...

Hard to see in the picture but it loops from the steering box and is under the radiator. It’s rusty. Can it be replaced with a soft line or is it high pressure?

On my 03 I broke the new top timing gear and I’m going to install another. What’s the best way to do it since I lost the timing marks when the gear broke? I know the gear only goes on one way and does #1 need to be TDC?

I replaced my oil pump and timing chain went to put my crank shaft pulley on and I’d didn’t go all the way in. So I thought I could turn it a little by hand and get the oil pump gear to slide back and get the pulley on. Well that didn’t go as planned. It wouldn’t turn and I may have tried a...

While cleaning up to put the oil pan back on I noticed this is it slipped liners or the bottom of the piston? If pistons is this normal?

So after 17 years it’s happened to my 03 Discovery,Coolant in my oil. Started the truck this morning smoked heavy for about a min or so. Drove to work that’s a little over a mile away drove fine. Checked coolant because no heat and no coolant in revisor. Put coolant in drive home not smoking at...

What size are the ones for a D2? i was going to order 3 from AB for 23.22 and the shipping was 20.01 and that seems a little high for 3 bolts and nuts.

03 D2 with a leak that I've been chasing since June and I think i've found it... maybe. Looks like its weeping where the front cover meets the block. its very slow but over time it'll add up. So i guess I'm looking at pulling the cover and resealing it. While I'm at i I'll do the timing chain...

03 Disco with over 202, 000 miles. I've been using Rotella for a few years along with Lucas. When I start the truck up its quite till it warms up then I get a tick at idle that will usually stop as soon as i push the gas, its usually at low speeds and doesn't get louder like the chatter from the...

Replaced the sensor on my 03 due to an erratic signal, the plug just fell apart under the hood. Put new one in and it didn't have a plug so i just cut the plug off and wired it up. Cleared the codes and drive it about 200 yards and it chimes and 3 amigos pop up. Read the codes and I get output...

Any trick to getting the passenger side rod end out of an 03 Discovery. I got the driver side out pretty easy. The passenger side wont move I know it's reverse threaded it wont move either way. Had someone point out that it looked like it was crimped in. I thought that was just for a tool to...

03 D2 replacing a ABS sensor and it doesn’t have a plug but is long enough to go to the ECU. I’m just going to splice into the current plug under the hood. The new wire is white and black. The one under the hood are both green. The plug has just crumbled away. And the old wire was whit and...

Replacing the roto flex in my 95 D1 how would one go about removing the center bearings or what ever it’s called.

95 D1 5 speed. Started having what appears to be a binding issue. Started a couple of days ago. Videoed the front diff noticed a catch and a clunk when it turned. Pulled the drive shaft videoed it again and saw the same thing with the rear drive shaft. It’s not every rotation but something is...

Got myself a leak on my 03 D2. Started slow and kinda intermittent then got worse. It’s not from the bottom of the pump, this is how the last pump leaked about 6 or so years ago. This looks like it is coming from around a bolt so I’m guessing the gasket has failed. I’m going to tighten the bolt...