Search results

List of things replaced since 2013: MAF Stepper Motor. Throttle Position Sensor Brakes and most brake lines (D90 Calipers on front, with D90 Rotors) Stainless flex lines front and back. Copper/zinc lines from ABS to Rear. EBC Pads with less than 5000 mi on them. Fuel Pump and pressure...

Won't start.Probably the starter, but I think I am done. List of things replaced since 2013: MAF Stepper Motor. Throttle Position Sensor Brakes and most brake lines (D90 Calipers on front, with D90 Rotors) Stainless flex lines front and back. Copper/zinc lines from ABS to Rear. EBC Pads with...

Turn the key, and you hear various relays clicking in the passenger footwell, but the starter is doing a thing. I used to be able to just turn off the key and try again, and it would fire right up. Not this time. I tried playing with the shift lever, brake pedal, but nada! Starter is about 2...

Looking for the plastic license plate lamp cover, and the handle that goes in side it: 1999 D1. Thanks in advance!

143000 mi. Mostly stock. Has a custom made baseplate for flat towing on it. Engine runs but I can't spend any more money trying to figure out why it idles at 2000 rpm. Tranny has problems too, so this is a good rolling chassis with good tfr case and rest of drive train. Most body panels in...

Hey guys, I have a 99 D1, 140k mi. on it. A while ago, I was having trouble with the stepper motor, and the engine would start at 2000 rpm and wouldn't kick down for quite a while. As this is my daily driver, it meant there were a few times I would be at a stop light, standing hard on the...

Hi All: 99 D1, 138k mi. Heads redone at about 128000 (about 2 years ago). In the past 6 months, I have noticed that in hot weather, the temp gauge is a little higher than normal, but not anywhere close to overheating. Now it's winter in the northeast, and the temp doesn't come up to normal...

Time for a brake rebuild. D1 has 130k mi., and front calipers are original. Rear calipers and flex pipes have been replaced. Using stainless flex pipes on rear, fronts are waiting for this rebuild. AB shows 4 different rebuild kits, ranging from $240 to $600. In the mix are the EBC kits...

Hey guys, I am looking for some help. I have a 99 D1. The other day, I noticed that my dash lights are not operating. As well, my right side rear marker lights are not working either. All other rear lights are working: Brakes, rear fog, turn signals, backup lights all work. I checked both...

Hi All: '99 D1 My a/c has been giving me trouble. It stopped cooling two weeks ago. Turns out, the 30 amp fuse in the engine compartment was blown. I replaced it and it blew again, immediately. I replaced the compressor, and we had to use a jumper wire instead of the fuse to start the...

Hey all: On a 2000 DII: Driver's widow got stuck in down position. We managed to take out the regulator, and found that the motor had "overshot" the extreme down position. It actually tried to carve gear teeth in the STOP (ungeared) part of the half moon gear. The motor's gear is in great...

I am in need of replacing the Valve Cover Gaskets. 99 D1, Gems Engine. Am I correct in assuming that I need to remove the plenum in order to get this done on the driver's side? I am asking because I want to know if there is a gasket there that I will have to order as well. Just trying to get...

Last year, I had to replace my steering box. Being new at all of this, and fairly incompetent, I wound up wrecking the original Rotary Cassette. I replaced it with a used replacement from a guy most folks find very reputable, and that one failed after about 3 months. I just finally replaced...

Hello to the more knowledgeable LR guys, I have a couple of questions: 1999 D1. 100,000 mi. on it 1.) I am about to redo my wheel bearings. My manual tells me to tighten the hub nuts to a specific torque. I only have a large set of channel locks that I can get them with, sooo.... where do...

I read somewhere that there is a x-ref for the D1 cooling fan and clutch to a GM part, but can't find it. Anyone know if this is true, and if so what or where? Thanks.

I have a 99 D1 SD. I need a cross referenced part # for the rear U-joint on the rear propshaft. Anyone able to tell me if one exists? Thanks.