Search results

Free located in W-NJ. Post if you’re interested and I’ll upload a few pics.

Trying my best, a few hours a week, to get my old Land Rover back to daily driver. Target drive-away in March 2023. My garage holds the IIa and my '95 RRC, but so much other hobby stuff it's not at all conducive to wrenching. That's the first hurdle as I organize and stage re-assembly.

This post for technical value, in case someone is searching for something similar in the future. I know EAS is not for everybody, but it suits this original RRC perfectly, and I really enjoy the benefits. The EAS ride is fantastic and this system has been in service for over four years. Back in...

Not mine, just stumbled across it... Full Ad here.

more CL fun below Show car range rover

Have an ABS light which I thought was the front-right ABS sensor, but it turns out the pad-wear sensor harness has broken wire. Anyone know if there is part number for the RRC front-right pad-wear sensor "harness"? It's included in this kit STC1864, but I only need the pad-wear harness not the...

SOLD - ARB Bumper - RRC non-winch version SOLD !!! The non-winch ARB bumper for the RRC. Will likely fit a D1 too. Structurally sound, cosmetically challenged - it's got a fair share of bumps and scrapes but solid and only some surface rust. A few small diameter bolt holes in the front face...

I've got a ARB non-winch bumper for a RRC. Structurally sound, cosmetically challenged - it's got a fair share of bumps and scrapes but solid and only surface rust. A few small diameter bolt holes in the front face, along with a dent, and the bull bar upper corners are drilled for limb riser...

I'm trying to ID the silver/gray paint code used on the center & lip of the CSK wheel. The CSK was a UK-only trim level (CSK = Charles Spencer King) but the wheels were used on a similar NAS model - the 1993 County Sable Edition. (Rangerovers.net: There were approx. 200 made with Beluga Black...

I have a 1995 RRC LWB with this coil wiring configuration. I spoke with AB about their relocation kit, and they have never seen the red & blue wires, nor do they know what to do with them regarding the relocation install. I'm hopeful that my 95 Classic shares these wires with either 1994 or...

Any tips on removing the facia fuse panel below the steering wheel? It looks like it has quick-release tabs along the perimeter, but I cannot get them to release and fear breaking the 21 year old plastic.

Are D1 and D2 spring loaded coin-trays/ash-trays interchangeable?

LWB :: 1995 Land Rover Range Rover County LWB (2015-12-08 13:49:31)

109 :: 1965 Land Rover Series IIa, exMoD 109 (2015-12-08 13:47:06)

Yeah, I know I'm opening the potential problem door, but I'm thinking of replacing our 1996 SD with an 2004 D2 for daily-driver and long haul trips. Our '96 is great, and I really think it was one of the few "good" ones. However, something with fewer miles and wear-n-tear would suit us better...

Running OBD2 software to evaluate my O2 sensors, I noticed something curious in the freeze frame data. My throttle position was indicated at 12% and the load at 30% - however the truck was idling in neutral?! I checked it several times and no change, other than a corresponding change in those...

When compared to a D1, how well does the DII age? I mean, there really isn't anything I can't get to/repair/rebuild on the D1. Are DII's basically the same in this regard? Regards, Tom P.

Is this a solution, or more of a problem? I have the rust starting to show up after a dealer fix 6 years ago(!). I kinda want to take care of it before it gets too bad, but it looks like a pain in the neck to get beneath the C-post. Regards, Tom P. 1996 Disco 1965 IIa 109

What can contribute to a P0420 fault code (Catalyst System Efficiency Below Threshold)? Beside faulty CAT(s)... My D1 has thrown a P0420 code twice in the past two months. New Y-pipe/dual CATs were installed ~11 months ago, to replace the original Y-pipe when the bank-1 CAT blew it's guts out -...