Search results

Installed my Land Rover block heater last weekend. Worked great with the cold weather we have had the last couple of days here in MN. It took a little bit of work to install as I needed to purchase a 17MM allen socket to pull the plug from the block. I am not sure what the easiest way to...

FOR SALE 1999 Land Rover Discovery II SE Miles 112,426 Dark Blue Interior Color Tan ________________________________________________________________________ Description: For Sale my 1999 LAND ROVER DISCOVERY II SE. It has the stock 18 inch wheels with 285/60R18 Nitto Terra Grappler All Terrain...

Does anyone in MN have an ABS code reader I could borrow?

Anybody in MN have the ABS Amigo or an ABS scanner that I could use on my Disco II?

I just completed swapping in a 4HP24 into my Disco II. It went out this winter when it was about -30* F out. I had just put in a block heater and had it plugged in that night and took it for a drive in the morning. It shifted really rough and skipped around bad. After that it would not go into...

I stuck a block heater in my '99 Disco II this weekend. Did outside, damn could this weekend. Was below 0 most of the time. Replaced the water pump as well since it started to leak. Never going to buy a reman unit again. Well, I decided to take for a spin this morning. It was about -5*F this...

Anyone have photos of the reluctor gear for the crankshaft position sensor?

I was curious about the ABS Modulator in the Disco II, when they fail what is usually the problem? Is it a relays that fail? I can't imagine that they very serviceable if at all. Has anyone tried to repair one?

I know that the tie rods on the Discovery is 11/16. What is the size of the adjuster's thread on drag link on the Disco II? Is it a 22 mm thread?

I read that the 300 TDI has gone through another change into a 4 valve 3 litre and 163 HP. Sounds pretty cool.

Looking for a back door panel for my Disco II. Need the panel and the pocket. Melted due to chemical being spilled. Watch that Deet. My seats are Bahama Beige.

So has anyone come across options for power steering pumps like the Disco I?

Has anyone successfully separate the engine control from their Disco II to either run a diesel or another engine control system? I was curious how tied in to the engine/transmission the SLABS, Heater control system and some of the dash items. I thought there was someone on her was running a...

I did a search, but most threads are for Disco I pumps. Are there any alternate pumps that work for a Disco II? If not where are the best prices? My Disco II's pump is noisy on cold mornings. I flushed the fluid, but it is still a little noisy. It actually all started after I cut about 2 inches...

Any good 4.6 short blocks out there for cheap? Or any 4.6 blocks?

My Disco II keeps blowing the fuse F2 under the hood. I noticed it since the check engine light was on and the code was saying voltage too weak at the MAF. I replaced it and it blew again after driving a little way. What else shares this fuse does anyone know? I am wonder if maybe I have a wire...

Anyone know what error codes a bad evaporative control valve could trip? Could it effect the MAF?

My Disco II wass giving me an error codes P1884, p0734 and P0174/P0171. I have tried two new MAF, but they did not solve the error codes. So I replaced the intake manifold gaskets and replaced the PCV hoses. I cleaned the intake manifolds. I also cleaned the plugs and put some dielectric grease...

Has anyone ever successfully stroked out a Rover block with a Buick 350 crank? Seems like a lot of crank to fit in the block. I have heard that it has been done but can't find any info about it. You would sure need some short rods.

Has anyone put an Isuzu Diesel in to a Discovery? It seems too tall. I can't imagine how they fit them in the Defenders in OZ. I was curious, did not find any post concerning this diesel.