I am selling these covers to a set of Hella 500 (6-3/8 inch) Driving or Fog lights.
The white covers are the factory supplied, but the clear are Hella add-on covers for constant rock protection.
Email or call David at: 720.940.6354.
I am selling two (2) Firestik CB (Citizens Band) antennas.
Four (4) foot Firestik Firefly - black
The "FL" Series antennas are the performance leader of lightweight top-loaded CB antennas. Each is approximately 40% lighter than the equivalent length Firestik II antenna. From the perspective of...
YEAHHHH, the only door that was not compressed closed was the front passenger side. The truck is not recoverable... To quote the tow truck driver after he had dragged it about 10 feet on its side... "I think your tie rod is busted!" Yeah no shit sherlock, otherwise I would drive it home...
Thank you for all of your well wishes... For the Colorado guys, we had just run Coney Flats to Middle St. Vrain and had a great day.
Rounding a corner on the Peak to Peak Highway just north of Ward Colorado I caught a sun glare with no sunglasses on and by the time I got the visor down my...
2000 DII - CDL - 245/75/16
I have a slight bend in some body panels that I can not explain. Is this a common occurence among DIIs?
- - - - - - - - - - - - - -
On the way home from a GREAT trail run today I found a nice soft shoulder on one of our Colorado two-lane highways...
Three - ABS, ETC, Downhill Decent.
You ABS faults out whether it be an actual failure of an ABS sensor or just a dirt or even a bad brake sqeak can cause a fault on the ABS sensor (probably the weakest link on the Disco).
Basically, your Traction Control (ETC) and Downhill Descent Control...
Scott, I do have a 2000 and the Latch is not in mine! I believe that they were installed in the 2001, but would need to hear from the 01 owners out there. Our 03 definately has them.
Where have you guys put your CB unit in your Disco? I spent an hour tonight trying to find just the right place and haven't yet found it.
Pics would really help!
I do like the OEM light bar, but I will take $12 in parts and 1.5 hours of labor over $150+ of my hard duckets any day. The OEM bar is stronger and more ridgid, but did I mention $12?
Finishsed Product
I finished the fabircation yesterday and the priming, painting, and install today. Took a midnight run around the neighborhood with my lights on and off to test and stop and adjust. Good thing I am on the HOA Board...!
Check out the finished pics...
Check out: http://discoweb.org/tire.htm
285/75-16 would fit, but you might have to trim a little and gearing could become an issue. If you are just looking for more grip, then go a little wider, but not taller.
Check out: http://www.miata.net/garage/tirecalc.html for exact tire size comparisons.
On the jam nuts... I did use an adjustable crescent wrench on one side and a vis grip on the other. I don't remember having an issue with that nut. All i can say is do you best and take the opportunity to go buy some new tools.
On the bolts... I have no idea!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.