Search results

so i bought the tie rod ends kit for my range rover through lucky8. that came with 3 RH thread ones and 1 LH thread one. where does the LH thread one goes? I have used all 3 of the RH ones.

so i got a question for you all. my wife and i went to salt lake we have filled up in heber and long story short we went 217 miles and only use 12 gallons then today we started heading back to duchesne we filled up in west valley utah and headed back home stopped in heber to use the bathroom and...

I am having the dreadful ticking sound from the top end of the engine and also the oil light comes on for about 5 mins and then shuts off. I been using 15w-30 oil in it and also been using reg gas do to prices. Well this have some to do with this? and should i change the oil and replace the...

I am going to be starting to build storage in the back of my range rover to have more room. I have got few things from work today to start working on it. I'll be using wood here's the sizes that I'll be working with 2x12, 2x4, and 1x4. The plans are for it is to cover my spare tire, but still...

I am going to be replacing fluids in my 91 range rover. Like the transmission, transfer case, axles. So I was wondering on what type of fluids would i need to do this?

I am looking for tail lights guards with hardware, passenger and driver side seat controls, rear windows control, rear ashtray. If you have any of these let me know on how much. Thanks in Advance...

since i am still new to land rovers. so here's my question would the brake calipers from a 94 D1 fit on a 91 range rover?

So I have decided to try and make my range rover like the camel trophy range rover. I have been search for parts but some stuff well have to be a little different. I also been to the camel trophy club to get info on what to do and what would make my range rover like the camel trophy. Also does...

Just wondering who's all in utah that owns land rovers. That would like to go wheeling sometime when i get my rover back on the road

this is the main build thread of my 1991 range rover. Right now as it sits it has the OME medium duty suspension rear is ome 764 and front is ome 761 with LT225/75R16 A/Ts and well be using the land rover brush guard. Things that i have replaced since i owned it are water pump, starter...

On your safari 31 gallon gas tank would it bolt right up on a 1991 range rover county and is there any other hardware needed?

I been doing research and writing down on stuff that i want to do to my RRC for the expedition rig. So my Question is would it be best to do the 24 spline and lt230 swap, or can I use the BW and 10 spline? It well only see dirt roads and mild rocks on the trail.

before i got the 1991 range rover county i had a 1990 Ford Bronco xlt that had the 5.0L v8 and 5 speed a year I paid $800 for the Bronco and $700 For the Rover. I have owned the rover for a year. I like the ride of the coil suspension over the leaf sprung vehicles. They both got the same MPG. So...

i am planning on restoring the range rover from ground up. and want to get new interior wiring harness and engine wiring harness. does any know where i can get them i have looked over at atlanticbritsh.com, roversnorth.com, lucky8.com, ebay and didnt come up with nothing so any ideas:banghead:

i have a Range rover classic brush guard and was wondering if i can get the rubber padding? to replace the old worn out ones. I might do a cheap expedition build. and keeping this. heres a pic of the guard that i have

was wondering how you can tell from the axle if its a 10 spline or 24 spline? :patriot:

i have been working on a 1991 range rover county. i have owned it for a year now. i have replaced the water pump, alternator, battery, starter, radiator hoses. Did a complete tune up with new spark plugs, wires, cap, rotor and a fresh oil change. It also has the old man emu MD shocks and coils...

i own a 1991 range rover county and my brake peddle got stiff and the abs pump stopped working. What would cause the abs pump to stop working?