So i have an on and off again loud tick on my 97 discovery. It never kicks in until it is warm, driving
More10 miles an hour it goes away. If i stop at a light and leave it in gear it is very audible, if i put it in park, it goes away. Then again, other times i drive and there is no noise...
Hi!
So my truck wasn't started for about 4 months while I replaced the heads and gaskets etc over the winter. Once done last wed I went to start it and the battery was dead. I charged the battery (too low to jump) and the truck started right up, it ran for about an hour that night and then I...
Hi,
Does anyone know if there are O-rings between the fuel line connections to the fuel rail? I can't figure out if they fell off when I removed the rail or if there aren't supposed to be any, can't find anything in rave about it either. Thanks for the help!
Tarmo
Hello!
Does anyone know what size the bolts are that hold down the RAM (air intake, horns, etc)? I snapped one and can't find that info anywhere. Thanks!
T
Hello,
I've been tracking an oil leak under my 1997 Discovery 1 that has been dripping/spraying onto the exhaust/cats and smoking like crazy. So I did an ok cleaning and found that the front oil seal was leaking, replaced it, and sleeved the shaft on the pulley. Leak fixed, great! Next day...
Hi,
So I set swivel pin preload on both front wheels a little while ago, afterwards I refilled the swivel's with gear oil. I've noticed now after driving that I get streaks of gear oil on the outside of the Rims, not on the inside or on the rotors, but only on the outside of the rim. Any ideas...
HI,
So I have a 97 Discovery and it is pulling to the left when I brake, without hitting the brakes the car goes straight... to try and fix the issue I have installed brand new front calipers and pads, bled the lines and I don't see any more air bubbles coming through... Any ideas as to...
Hey,
So the hard brake lines that go from the front of my 97 disco to the back rusted through and need replacing, no problem. I unscrewed the lines in the front with no issues. I got the fittings in the back where they connect to the flexible line/hose open also, but i was surprised to find...
Hey,
So the hard brake lines that go from the front of my 97 disco to the back rusted through and need replacing, no problem. I unscrewed the lines in the front with no issues. I got the fittings in the back where they connect to the flexible line/hose open also, but i was surprised to find...
Hi,
I just installed a new super gaz gas steering damper which I got from atlantic british... removal and install went really easily... afterwards my disco pulls a bit to the right. I heard that the gas steering dampers can pull a bit... does anyone know if this is something that needs to...
Hi,
The rear passenger 02 Sensor on my 97 disco did not come out very well.... most of the thread on the sensor ended up becoming part of the socket that it screwed into on the exhaust pipe. Does anyone know what size Tap to use to fix the threads in the hole?? This must've happened to...
Hi,
I have a strange issue that I can't seem to figure out. Every now and then after I've driven for a while, stopped and turned the car off and then tried to start the truck when it is hot, it will run rough idle will go quickly from 750 to 0 and it will stall, if it gun the gas and get...
Hello,
I'm having a problem with a rattle and squeal with my new front brake pads (97 Disco). I put on a set on Mintex front pads (new rotors also)and noticed a rattle most of time. So I decided to try Ferodo pads.... rattle gone but replaced by a squeal. I have driven well over 1000...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.