Search results

I believe the color is bahama beige. It is the darker tan color with the same color piping.

My 01 DII's steering gear has been making noise for a while. I sourced a new gear sometime last year from Will. Anyway a couple of weeks ago my PS pump grenade so I ordered a new pump and plumbing to go on with the used gear. I've got her all buttoned up and filled and bled, but it wants to...

I'm running 265/60-18 Toyo Open Country ATs on my 04 DII. They should equate to about a 30.5" tire. I'm guessing that they would look small with RTE 2" HD springs. Does anyone have a pick of that lift and 30" tires? Thanks in advance!

I've got a dead window motor in my front passenger window. I have a motor from a newer RRC, but the plugs are not the same. My old motor has a flat 2 wire connector where the new one has a round connector. Would the newer motor work if I were to replace the connector?

The next part in my quest to solve my hot start issue is the amplifier module. I've got an 88 RRC with the original 3.5 and 150k on the clock. Why is there such a discrepency from AB and RN on their modules? Genuine/Aftermarket? Is the cheaper AB one worth getting...

I'm looking for a spare center dash fascia for my 04 DII to mod up for a double din stereo install. This would be the trim that the radio, a/c controls, center vents, coin and ash trays mount to. Edit - Per Crown14 it sounds like other than color they are all the same going back to 94. Given...

No rush, but I'm going to need a right passenger side upper and lower tail light lens for my 04 DII and possibly a coin tray.

After further review we are looking for an 04 DII HSE7 with rear air. ~ 75k miles White, Black, or Bonatti Gray tan or black interior w/rear air

I've got a new RTE Drag Link and need to replace my old RRC 88 steering box drop arm with a newer model that does not have the tie rod end encorporated in the arm. NEED ASAP! Thanks Jeff

I lost a hose on the AC last week. My old compressor also seemed to be leaking out of the front seal a bit. I picked up a good compressor from Will a while back so that will be going on and have a local shop to make a new hose for me. Other than a new Drier is there anything else I should...

I'm looking for the following : Front Floor Mats Drivers Side Rear Seat Belt Assembly. My reel is FUBAR'd and won't pay out the belt. Driver's door seal. Passenger Side Rear door seal. Really just the short curved piece on the bottom angled part of the door. No idea where mine went....if I...

I picked up a set of Maxxix Bighorns on Friday. I haven't gotten to ride them around much or wheel them yet, but my first impressions are that I am going to love these. I've also determined I must have lost a wheel weight at some point as ride smoother than my old "street" ATs. I think this...

I'm looking for a set to try out on my 88 RRC before I spend some real coin on a new set. Thanks, Jeff

Ok, just installed my RTE / OME steering dampner relocation kit on my 88 RRC. Looking at the OME bushings I had 4 bushings and 4 washer cups. That didn't look quite right to me so I borrowed a couple of washer cups from the old dampner. The high side by the frame looks good, but the low side...

Has anyone replaced the Girling brake fluid reservoir with any luck? I have a fluid leak somewhere in the master cylinder area. I was thinking about going ahead and springing for the master cylinder, but the fluid leaks from the Max level to the Min level mark and then stops. It never goes...

I need a front driver's seat buckle for an 88 RRC. The female part connected to the seat that the belt plugs into. Mine decided it was done plugging today.

I'm looking for a nice ARB or RTE bumper for my RRC. I'll have a nice LR brush guard to sell/trade after the swap.

I've got a couple of AB gift certificates that are burning a hole in my pocket. New lights sound good, although I should be getting a new alternator instead. I'm currently sporting the LR brushguard on my 88 with plans to move to an ARB or RTE at some point. So I plan on moving the lights to...

Looking for a complete jack kit : Jack, lug wrench, and extensions.

Need a new knob, mine came stripped.