Search results

In search of late series 2a grille.

Can't seem to find the torx head size to remove the airbag module from my '02 DII. Other than disconnecting the battery for at least 15 minutes, and leaving the steering wheel at 6 and 12 o'clock, does anyone have any other tricks for getting this out as well as the torx head size for these two...

So I replaced my plugs this morning, afterwards I was trying to track down some amp issues I've been having by checking the grounds under the passenger seat. I tried to turn her over but the car wouldn't start and the hazards came on and won't shut off. I'm assuming I have pissed off the...

Watch this: http://www.youtube.com/watch?v=lVJTJpfknSc&feature=related Then this: http://www.youtube.com/watch?v=V5K7uh0iVDs&feature=related WOO WOO

I'm going to purchase my first handgun in January for all around use; home, range. Any preferences between the Sig and Glock?

Anyone know any decent LR mechanics on Cape Cod or somewhere close by? I know of Cityside Garage in Holliston but that's a bit too far away. I'd hate for my only option to be the stealership......

Don't give me too much grief for this but does anyone have any invites for Yay Hooray that they want to send my way? ccredsox at yahoooooo dot com (www.yayhooray.com)

2002 DII SE7 I seem to have a rumbling that I can feel under the passenger side footwell. I have DBA rotors so I don't think they are necessarily the issue. I'm thinking I have either a seized front left caliper, a bad wheel bearing (only 95k on the odometer though) or a transfer case...

I'm trying to replace the front fog light bulb on my '02 DII and I'm not having much luck. Is there some sort of trick to pulling these? It looks like the old bulb was epoxied in or something and I've already broken the bulb trying to get it out. Any help would be appreciated. Mark

'92 Classic for sale, Ardennes Green. 130K Needs work (obviously) New cats should be welded in, the 02 sensors are fairly new. Brake lines should be changed due to deterioration Underbody is rusting, frames don't seem bad. The car cosmetically looks good, headliner starting to sag a bit in...

I'm having excessive rattling coming from the driver's side heat shield on the Cat. Is it a big deal if I take it off or is it absolutely necessary? I don't have a welder handy to make a quick bead on the crack. thanks for any help

Anyone know the Tinnerman Clip size for the lens that shields the license plate bulb on a '02 Disco?

Failed MASS emissions with my '92 RR. Results were: CO2 at 2390 RPM was 13.6 at idle they were 13.2 CO was 3.05 at 2428 RPM at idle they were 2.93 HC was a range of 140 to 149 the test failed at CO because the cut point was a 2 and I scored a 3.05 so i'm not sure what the cut point for CO2...

Just came back from the local tire place (sullivan tire) to get my wheels balanced. This was my final stage of dealing with my high speed vibration and it turns out I need some new tires due to so severe tire degredation in the rear wheels. I don't want to just swap out the back two because...

Hey everyone, What kind of champion plugs are recommended for a 02 DII? What should the gapping be set at and what torque should be applied? Sorry but I searched and couldn't find exactly the info I needed. Thanks Unless I should get bosch plats. kidding

Anyone ever have a problem with leakage from the rear diff on a 2000 DII? Looked all over for the leak but couldn't find it. Any problematic areas that usually come up? thanks

I use my 2002 SE7 as my commuter car and was wondering what the best option is for a driveshaft replacement. This particular rover of mine has very limited off road use so that should not be a factor in my purchase. Any help would be greatly appreciated!

I have a bad vibration at 70 mph. I'm doing the front driveshaft this weekend to replace the u joints. Is there a way I can figure out if that is def. the problem I have? I know I need to overhaul the driveshaft anyways, just wanted to make sure that is the problem

can someone tell me what model # (from optima) i need for my discovery II? thanks

The rover failed Massachusetts emissions a couple of months ago and this was after I changed out the O2 sensors! I need help! I even had installed a NRP catback s.s. exhaust. I'm hoping that the problem isn't with the catalytic converters. Anyone have any information? The exhaust really...