I have 04 Disco. 2nd to last battery lasted 3 years. Last battery lasted 12 months. I replaced battery today and truck starts fine. I put multimeter on and alternator in charging battery at 14.5V. I was told alternator should not charge above 14.2V. Does this sound right?
I'm looking to sell my 04 Disco SE Silver / Black leather and I was wondering how much they sell for? Truck is in CT.
Here are the details
Good:
Reman AB top hat liner 4.6 engine at 135K, truck now has 145K miles - many many parts replaced when this was done. In hindsight I should have just...
new coolant leak, in the right (passenger) front. Looks to be seem on lower part of radiator or lower coolant hose. I pressure tested, but could not get issue to occur, so I don't think its the coolant hose, more likely the seem between aluminum and plastic. Running engine now and trying to find...
I have 04 Disco with 140K miles on it, right rear brake caliper has seized. Whats the best replacement for the money? Do rebuilds last or am I better getting new? If new how does TRW brand stack up to LR? Are they the same?
LR part STC1906 ~ $275 new
TRW W0133-1606625 ~ $100 new
Napa...
Has anyone figured out how to fix the rocking drivers seat on 04 Disco?
Does the drivers seat from an "S" have the same issue?
If not, does the "S" seat fit in the "SE" model?
thanks
Do I have the connectors plugged into the right spot?
Truck is 04 Disco. The black and gray connectors are the same style and I just don't remember how they where before swapping out the engine.
http://www.flickr.com/photos/20625046@N08/8333728293/in/photostream
thanks
I have 04 Disco, but the drivers side rear is 1/4 inch lower than the left. Truck has stock springs with 137k miles on it. Land Rover OEM springs are $600 for all 4. AB has some OMU/ARB ones for $380 and Allmakes for $370 and Terrafirma for $270. What's the closest to OEM, without paying $600...
I replaced the engine in the 04 Disco and I had a small leak at the heater hose, so I cut the hose off and I noticed that I did not clean up the black RTV on the heater hose connectors on the firewall side. So I just cleaned it up with a razor.
Should I re-RTV the heater hose connector? Was it...
On 04 Disco is it best to fill the coolant to a little below the cold line indicated on the expansion tank? Reason I ask is I slightly overfilled it by 3/16 of an inch and that's pretty much what the Disco got rid of via the tube that's near the neck of the expansion tank. I did check for...
I have 04 disco with re-man short block from AB with top hat liners. When doing the rebuild I used PEL500110 thermostat. Driving temps are now 184-193. I think they use to be 206. So it certainly seems to help.
I just replaced the engine in my 2004 Discovery with re-manufactured short block, but not sure what this part is and where is goes on the truck.
picture of the part here:
http://www.flickr.com/photos/20625046@N08/8238342654/in/photostream
thanks
I just replaced the engine in my 2004 Discovery with re-manufactured short block, but not sure what this part is and where is goes on the truck.
picture of the part here:
http://www.flickr.com/photos/20625046@N08/8238342654/in/photostream
thanks
Which is the best new v8 engine for 2004 Land Rover Discovery?
1- Turner Engineering UK
http://www.turner-engineering.co.uk/html/V8enginesnew.html
4.6V8 NEW short engine assembly - New block casting fitted with ductile iron flanged liners, crankshaft, pistons, conrods, camshaft & timing...
I have 04 disco d2 with 125K miles. The fan squeaks at low speed, if I turn all the way up it stops squeaking. I see a fan under the glove box. Is that the fan? Is this fan serviceable? Such as spray silicon or something else to stop the squeak?
thanks
I have coolant leak on bottom nipple of expansion tank. Going to fix tomorrow. But I have one question. Are the coolant lines suppose to get very hot? i.e. too hot to touch after running truck for 3-4 minutes at stand still? The coolant lines also get a little hard, I can still press them in but...
I have 04 Disco than most likely needs head gasket. Truck is at Robison Service in Ma. Truck has 117K miles on it and last had head gaskets replaced under warranty at 35K. What has been presented so far:
1-Change valley gasket and use stop leak for head gasket and hope for best - cost ~2K...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.